Viking Repair Experts Los Angeles, CA · Westside & central
8:00 am – 8:00 pm, seven days (213) 600-7131
A spring-loaded scissor hinge mechanism with its roll pin, small brackets and clips, laid out on canvas with drivers

Los Angeles, CA · ZIP 90004

Viking repair in Hancock Park

Spanish Revival and Tudor homes from the 1920s, with tight original kitchens and butler’s pantries.

01 What changes here

Hancock Park kitchens, and what they do to the equipment

  • Flames orange and lazy rather than blue
  • Dishwashers backing up where the drain was retrofitted
  • An oven that browns hard on one side in a tight alcove

The 1920s houses here were never built for a professional range, and mostly the range has been fitted into a space that used to hold something much smaller. Ventilation is the usual casualty: not enough make-up air, a hood that cannot keep up, and burners running rich as a result.

That shows up as orange lazy flames, air shutters full of lint and dust off old floor vents, and soot where there should not be any. It is a maintenance fault rather than a failure, and it is worth fixing properly — a burner running rich is also a burner running hot on everything around it.

02 Outside the back door

Outdoor kitchens in Hancock Park

Built-in grills are the larger half of what this shop does, and the questions they raise are about the island as much as the appliance.

Away from the coast the grill is more often a cart standing on a terrace than a unit set into stone, which changes the work entirely: the regulator and hose are reachable, the cylinder or the quick-connect is the first thing to check, and a whole class of island problems simply does not arise. What does arise is dust in the venturis on a still, hot afternoon.

The whole of it — burners, igniters, trays, the rotisserie burner and the gas run that feeds them — is on outdoor grill and kitchen repair.

03 In Hancock Park

What we are called out for

The same five kinds of work everywhere the van goes — the difference is which of them Hancock Park generates most of.

  1. On the phone

    Three things: how it behaves now, how it behaved last week, and the number off the plate if the plate is reachable. That narrows most calls before anyone sets off.

  2. At the appliance

    Meter, gauges, flame pattern, current draw. You get told what failed and what putting it right involves, with the price agreed before a panel comes off.

  3. Afterwards

    The old part stays with you if you want to see it, the appliance gets run up and tested, and the $89 visit comes off the bill.

04 After the visit

From Hancock Park and around it

5.0 / 51,384 reviews

  • “Control panel went dark in the middle of a heat wave, though the box inside was still cold. A failed power board behind the grille. He had one on the van and was away within the hour.”

    Naveen S. · Hancock Park · June 2026

  • “Every flame looked orange and lazy in a 1920s kitchen with almost no ventilation. The air shutters were choked with lint and dust off the old floor vent. Ten minutes and the flames went blue again.”

    Haruki N. · Hancock Park · March 2026

  • “A cycle that took an hour was running most of the afternoon. The thermistor read low, so the machine sat waiting for heat it already had. One sensor, sorted.”

    Herschel M. · Hancock Park · April 2026

Get somebody out to Hancock Park

Tell us the model and what it is doing. $89 covers the visit and the diagnosis, and comes off the repair.

$89 for the visit and the diagnosis, credited against the repair. Work carried out 8:00 am – 8:00 pm, seven days.